Saw Parts

Tired of your adjustable tension levers on the BT3K not being tight or loose enough? Replace them with fully adjustable ratcheting levers that allow much more precision in the torque of your rail mounting. These levers are a direct replacement and require no additional parts. Just use the original square t-nut and black washer from the stock plastic lever and bolt combo, and insert this lever instead. This lever can also be positioned such that it locks into place and will not loosen with...

Steel setscrews with 1/4-20 thread and nylon-tipped for fixing the Fixture Block to the rail. Use as replacements or spares or for any other use where a non-marring setscrew is required.

Take shortened extended rails from a wide table kit and attach these hinges and you can have a folding wide table. The hinges attach securely with included stainless screws and T-Nuts, and have no slop or play in the hinge joint. Long rail extensions (full-length) can't fully fold under a standard BT3 setup, as the rail is longer that the height of the saw (unless your saw is on a specially made higher stand). Full-length rails can be cut in half and two sets of hinges used to make a compound...

Fits Ryobi BT3000/BT3100 and Craftsman 21829/22811 series table saws: Rip Fence, Left Side SlotSliding Miter Table (SMT) Fence, Front SlotRear Rail, Rear Slot Aluminum, available in 10-32 thread

Fits Ryobi BT3000/BT3100 and Craftsman 21829/22811 series table saws: Front Rail, Top Slot Available in 1/4-20 and 5/16-18 thread, with a black-oxide finish. A limited supply of 1/8" pilot hole units with a black-oxide finish, are also available.

Fits Ryobi BT3000/BT3100 and Craftsman 21829/22811 series table saws: Rip Fence, Right Side SlotSliding Miter Table (SMT) Fence, Rear SlotFront Rail, Inside SlotFront Rail, Bottom SlotRear Rail, Inside Slot Available in 5/16-18 thread with a black-oxide finish.A limited supply of 1/8" pilot hole units with a zinc finish, are also available.  Use these when custom threads are required. ...

Fits Ryobi BT3000/BT3100 and Craftsman 21829/22811 series table saws: Rip Fence, Top SlotSliding Miter Table (SMT) Fence, Top SlotRear Rail, Bottom Slot Available in 1/4-20 and 5/16-18 thread, with a black-oxide finish. A limited supply of 1/8" pilot hole units with a zinc finish, are also available.  Use these when custom threads are required.

Fits Ryobi BT3000/BT3100 and Craftsman 21829/22811 series table saws, this t-nut assortment pack is designed for use with custom rail extensions.  Package contains the following:4 x XL5 X-Large T-Nut (5/16-18 thread)Rear Rail, Bottom Slot12 x LG5 Large T-Nut (5/16-18 thread)Rear Rail, Inside SlotFront Rail, Bottom SlotFront Rail, Inside Slot With this supply of t-nuts, extension rails can be securely joined with two t-nuts on either side of joint on both the inside and bottom slots...